TOYOTA MR2 STEREO REMOVAL GUIDE

TOYOTA MR2
1989-2000
REMOVAL INSTRUCTIONS:
FIRST REMOVE THE GEAR GATOR & BEZEL FROM THE CENTER CONSOLE, NEXT REMOVE THE ASHTRAY & REMOVE THE TWO SCREWS LOCATED BEHIND, NOW REMOVE THE ONE SCREW LOCATED UNDERNEATH THE STEERING WHEEL  JUST BELOW THE CIGAR LIGHTER, ONCE REMOVED YOU CAN PULL THIS PANEL FORWARDS DISENGAGING THE METAL CLIPS, THERE ARE TWO MORE SCREWS HOLDING THE LARGE PANEL IN PLACE, ONCE REMOVED YOU CAN LEVER THE WHOLE PANEL AWAY FROM THE DASH STARTING AT THE BOTTOM, ONCE THE PANEL HAS BEEN REMOVED YOU CAN NOW ACCESS THE SCREWS HOLDING THE STEREO IN PLACE.
EXTRA INFORMATION:
N/A
Picture
DIFFICULTY RATING:
TOOLS REQUIRED:
Picture
TRIM REMOVAL TOOL
Picture
PHILLIPS SCREWDRIVER
ACCESS REQUIRED:
Picture
WIRING HARNESS
Picture
AERIAL ADAPTER
 Difficulty Key:
* Straightforward install requiring little or no trim removal & minimal fitting skill/experience.
** More complex installation including bolt-in Head Unit &/or trim removal. 
*** Complex installation including Hard Wiring, bolt-in Head Unit & extensive trim removal.
 Where to find the Correct Fascia & Harness Adapters:

              - ArmourAutomotive.com (Autoleads)
              - Connects2.co.uk