NISSAN 350Z STEREO REMOVAL GUIDE

NISSAN 350Z
2004 ON

REMOVAL INSTRUCTIONS:

REMOVE THE GEAR GAITER SURROUND  BY PULLING THE GAITER APERTURE UPWARDS DISENGAGING THE CLIPS, NOW UNSCREW THE GEAR KNOB & REMOVE THE WIRING CONNECTORS & PLACE TO ONE SIDE, NEXT REMOVE THE TWO SCREWS AT THE BOTTOM OF THE CENTER PANEL JUST BELOW THE STEREO, NOW REMOVE THE RUBBER COVER IN THE POCKET ABOVE THE STEREO & REMOVE THE TWO SCREWS BEHIND, ONCE REMOVED YOU CAN TAKE OUT THE STRIP THAT WAS HELD IN PLACE, ONCE DONE THERE ARE TWO SCREWS SET BACK IN THE DASH THAT NEED TO BE REMOVED (REACHABLE USING A LONG SCREWDRIVER), NEXT REMOVE THE FOUR SCREWS LOCATED ALONG THE BOTTOM EDGE OF THE AIR CONDITIONING UNIT & WITHDRAW FROM THE DASH, FINALLY YOU CAN REMOVE THE CENTER DASH PANEL, GRASP THE PANEL AT THE BOTTOM & GENTLY LEVER OUT OF THE DASH WORKING UPWARDS DISENGAGING THE CLIPS. ONCE REMOVED YOU CAN NOW ACCESS THE SCREWS HOLDING THE STEREO IN PLACE.

EXTRA INFORMATION:

AN EARTH CONNECTION WILL NEED CONNECTING TO THE AFTERMARKET HARNESS LEAD.

VIDEO FITTING LINKS:

DIFFICULTY RATING:

---

TOOLS REQUIRED:

TRIM REMOVAL TOOL

---

PHILLIPS SCREWDRIVER

---

SMALL FLAT HEAD SCREWDRIVER

---

ACCESS REQUIRED:

WIRING HARNESS

---

FASCIA ADAPTER

---

AERIAL ADAPTER

---

 Difficulty Key:
* Straightforward install requiring little or no trim removal & minimal fitting skill/experience.
** More complex installation including bolt-in Head Unit &/or trim removal. 
*** Complex installation including Hard Wiring, bolt-in Head Unit & extensive trim removal.

 Where to find the Correct Fascia & Harness Adapters:

              - ArmourAutomotive.com (Autoleads)
              - Connects2.co.uk