MAZDA MX5 STEREO REMOVAL GUIDE

MAZDA MX5/EUNOS/ROADSTER
1992-1998

REMOVAL INSTRUCTIONS:

YOU NEED TO REMOVE THE CENTER CONSOLE & THEN THE DASH TRIM SURROUNDING THE STEREO & HEATER CONTROLS ETC. FIRST REMOVE THE TWO SCREWS AT THE FRONT OF THE PANEL COVERING THE TRANSMISSION TUNNEL, THEN ONE SCREW UNDER THE ASHTRAY & ANOTHER TWO LOCATED IN THE STORAGE POCKET AT THE REAR OF THE PANEL, NEXT REMOVE THE GEAR KNOB & LIFT THE WHOLE CONSOLE UPWARDS AT THE FRONT & SLIDE FORWARDS MAKING SURE TO CLEAR THE BOOT RELEASE & PETROL CAP LEVERS. WITH THE CENTRE CONSOLE REMOVED NOW REMOVE THE SCREW LOCATED AT THE BOTTOM LEFT CORNER OF THE DASH PANEL, NEXT REMOVE THE TWO SCREWS LOCATED BEHIND THE TWO VENTS AT THE TOP OF THE PANEL (THE VENTS ARE HELD IN PLACE WITH METAL CLIPS & SIMPLY LEVER OUT OF THEIR HOUSING), WITH THE TRIM PANEL REMOVED YOU CAN NOW ACCESS THE SCREWS HOLDING THE STEREO IN PLACE.

EXTRA INFORMATION:

N/A

VIDEO FITTING LINKS:

DIFFICULTY RATING:

---

TOOLS REQUIRED:

TRIM REMOVAL TOOL

---

PHILLIPS SCREWDRIVER

---

ACCESS REQUIRED:

WIRING HARNESS

---

FASCIA ADAPTER

---

AERIAL ADAPTER

---

 Difficulty Key:
* Straightforward install requiring little or no trim removal & minimal fitting skill/experience.
** More complex installation including bolt-in Head Unit &/or trim removal. 
*** Complex installation including Hard Wiring, bolt-in Head Unit & extensive trim removal.

 Where to find the Correct Fascia & Harness Adapters:

              - ArmourAutomotive.com (Autoleads)
              - Connects2.co.uk