HYUNDAI i10 STEREO REMOVAL GUIDE

HYUNDAI i10

REMOVAL INSTRUCTIONS:

STARTING AT THE BOTTOM EDGE OF THE LARGE TRIM SURROUND THAT ENCLOSES THE STEREO AND TWO CENTRE VENT ASSEMBLY'S, CAREFULLY LEVER THE WHOLE PANEL INCLUDING VENTS AWAY FROM THE DASH USING A TRIM REMOVAL TOOL (ITS HELD IN PLACE WITH QUITE STRONG RETAINING CLIPS), ONCE THE TRIM PANEL SURROUND IS REMOVED YOU CAN NOW ACCESS THE FOUR PHILLIPS SCREWS HOLDING THE STEREO/RADIO IN PLACE.

EXTRA INFORMATION:

CERTAIN MODELS ARE FITTED WITH A HYUNDAI WIRING HARNESS BLOCK AND WILL REQUIRE AN AFTERMARKET WIRING HARNESS TO MAKE THE WIRING COMPATIBLE WHEN FITTING AN AFTERMARKET STEREO. ALTHOUGH MOST MODELS HAVE STANDARD ISO WIRING AND DO NOT REQUIRE ANY ADDITIONAL WIRING. (REMOVAL OF THE STANDARD STEREO IS REQUIRED TO FIND OUT WHICH ONE YOU REQUIRE)

DIFFICULTY RATING:

---

TOOLS REQUIRED:

TRIM REMOVAL TOOL

---

PHILLIPS SCREWDRIVER

---

ACCESS REQUIRED:

FASCIA ADAPTER

---

AERIAL ADAPTER

---

 Difficulty Key:
* Straightforward install requiring little or no trim removal & minimal fitting skill/experience.
** More complex installation including bolt-in Head Unit &/or trim removal. 
*** Complex installation including Hard Wiring, bolt-in Head Unit & extensive trim removal.

 Where to find the Correct Fascia & Harness Adapters:

              - ArmourAutomotive.com (Autoleads)
              - Connects2.co.uk